D-Link DSL-2600U Quick Installation Guide

U
If the error “The page cannot be displayed” (or “Unable to
display the page”/“Could not connect to remote server”) occurs
upon connecting to the web-based interface of the router, make
sure that you have properly connected the router to your
computer.
U
ﻱﺎﻄﺧ ﻡﺎﻴﭘ ﺎﺑ ﺮﮔﺍ“The page cannot be displayed” ﺎﻳ
U
“Unable to display the page”/“Could not connect to remote
server” . ﺪﻳﻮﺷ ﻦﺌﻤﻄﻣ ﺮﺗﻮﻴﭙﻣﺎﻛ ﻪﺑ ﺮﺗﻭﺭ ﺢﻴﺤﺻ ﻝﺎﺼﺗﺍ ﺯﺍ . ﺪﻳﺪﺷ ﻪﺟﺍﻮﻣ
After successful registration the system statistics page opens.
The page displays general information on the router and its
software.
ﺯﺎﺑ ﻪﺤﻔﺻ . ﺪﺷ ﺪﻫﺍﻮﺧ ﺯﺎﺑ ﻢﺘﺴﻴﺳ ﻪﺑ ﻁﻮﺑﺮﻣ ﺕﺎﻋﻼﻃﺍ ﻪﺤﻔﺻ ، ﺰﻴﻣﺁ ﺖﻴﻘﻓﻮﻣ ﺖﺒﺛ ﺯﺍ ﺲﭘ
. ﺪﻫﺩ ﻲﻣ ﻥﺎﺸﻧ ﺍﺭ ﻥﺁ ﺭﺍﺰﻓﺍ ﻡﺮﻧ ﻭ ﺮﺗﻭﺭ ﺎﺑ ﻁﺎﺒﺗﺭﺍ ﺭﺩ ﻲﻠﻛ ﺕﺎﻋﻼﻃﺍ ﻭ ﻩﺪﺷ
U
It is strongly recommended to change the administrator
password upon initial configuration of the router. To do this, go
to the MAINTENCE/Password page.
U
ﺍ ﺭﻮﺒﻋ ﺰﻣﺭ ﻪﻛ ﺩﺩﺮﮔ ﻲﻣ ﻪﻴﺻﻮﺗ ﺍﺪﻴﻛadministrator . ﺪﻴﻨﻛ ﺽﻮﻋ ﺍﺭ ﻢﺘﺴﻴﺳ
ﻪﺤﻔﺻ ﻖﻳﺮﻃ ﺯﺍ ﺭﺎﻛ ﻦﻳﺍ ﻡﺎﺠﻧﺍMAINTENCE/Password ﻦﻜﻤﻣ. ﺖﺳﺍ
U
!
!
!
!
12

D-Link DSL-2600U Specifications

Power

input voltage	100V-240V
input current	0.6A
input frequency	50 Hz - 60 Hz
output voltage	12V
output current	1A

Data Transfer Rates

G.dmt full rate downstream	up to 8 Mbps
G.dmt full rate upstream	up to 1 Mbps
G.lite ADSL downstream	up to 1.5 Mbps
G.lite ADSL upstream	up to 512 Kbps
G.dmt.bis full rate downstream	up to 12 Mbps
G.dmt.bis full rate upstream	up to 1 Mbps
ADSL2+ full rate downstream	up to 24 Mbps
ADSL2+ full rate upstream	up to 1 Mbps
IEEE 802.11b wireless transfer rates	11, 5.5, 2, and 1Mbps
IEEE 802.11g wireless transfer rates	6, 9, 12, 18, 24, 36, 48, 54 Mbps

Interfaces

ADSL interface connector	RJ-11
LAN interface port	RJ-45
LAN interface standard	10/100BASE-T Ethernet