Dual Band AC1750 Gigabit ADSL2+ Modem Router User Manual
Web User Interface Configuration Page 120
In this section, the following parameters can be configured:
UDP Endpoint Filtering: Select the UDP end-point filtering method here. The
Endpoint Independent option will forward any UDP incoming traffic, sent to an
open port, to the application that opened the port. The port will close if idled for
5 minutes. The Address Restricted will check whether UDP incoming traffic
matches the IP address of the outgoing connection. The Port And Address
Restriction option will check whether UDP incoming traffic matches the IP
address and port of the outgoing connection.
TCP Endpoint Filtering: Select the TCP end-point filtering method here. The
Endpoint Independent option will forward any TCP incoming traffic, sent to an
open port, to the application that opened the port. The port will close if idled for
5 minutes. The Address Restricted will check whether TCP incoming traffic
matches the IP address of the outgoing connection. The Port And Address
Restriction option will check whether TCP incoming traffic matches the IP
address and port of the outgoing connection.
In this section, the following parameters can be configured:
Enable anti-spoof checking: Tick this option to enable the anti-spoof checking
feature.
In this section, the following parameters can be configured:
Enable DMZ: Tick this option to enable the Demilitarized Zone (DMZ) feature.
DMZ IP Address: Enter or select the local DMZ IP address here.
To Next Page
Loading...
