Dual Band AC1750 Gigabit ADSL2+ Modem Router User Manual
Web User Interface Configuration Page 48
In this section we can configure the following parameters.
Enable Wireless: Tick this option to enable the wireless feature for the 2.4GHz
band on this router. Use the drop-down menu to apply a time schedule to this
wireless network.
Wireless Network Name: Enter the wireless network name (SSID) here. This
name will be available when wireless clients scan for available wireless
networks. However, when the Visibility Status option is set to Invisible, this
name will not be visible to wireless clients.
802.11 Mode: Here we can select which 802.11 wireless modes to use. Options to
choose from are 802.11b only, 802.11g only, 802.11n only, Mixed 802.11g
and 802.11b, Mixed 802.11n and 802.11g, and Mixed 802.11n, 802.11g and
802.11b. If you are not sure, select the Mixed 802.11n, 802.11g and 802.11b
option.
Enable Auto Channel Scan: Tick this option to allow the router to find and use the
wireless channel with the least interference in your environment.
Wireless Channel: Here we can manually select a wireless channel.
Transmission Rate: Here we can select the wireless transmission rate. It is advisable to keep this option on Best.
Channel Width: Here we can select the wireless channel width used. Options to choose from are 20MHz and 20/40MHz (Auto).
Visibility Status: Here we can choose to hide the Wireless SSID by selecting Invisible to hide it and Visible to reveal it.
Wireless Security Mode - None
This router supports four wireless security mode options available in the Security
Mode drop-down menu for the 2.4GHz band.
The first security mode is called None. By selecting this mode, there will be no
wireless security applied to your wireless network. This means that anyone with a
wireless adapter can connect to your network.
To Next Page
Loading...
Need help?
General
