Dual Band AC1750 Gigabit ADSL2+ Modem Router User Manual
Web User Interface Configuration Page 79
In this section, the following parameters can be configured:
Enable Automatic IPv6 address assignment: Tick this option to enable automatic
IPv6 address assignment.
Autoconfiguration Type: Select the IPv6 auto-configuration type here. Options to
choose from are SLAAC+RDNSS, SLAAC+Stateless DHCP, and Stateful
DHCPv6.
IPv6 Address Range (Start): After selecting Stateful DHCPv6 as the auto-
configuration type, enter the starting IPv6 address and prefix for the range
here.
IPv6 Address Range (End): After selecting Stateful DHCPv6 as the auto-
configuration type, enter the ending IPv6 address and prefix for the range here.
IPv6 Address Lifetime: After selecting Stateful DHCPv6 as the auto-configuration
type, enter the IPv6 address lifetime value here.
Click the Save Settings button to accept the changes made.
Click the Don’t Save Settings button to discard the changes made.
IPv6 Connection Type – Auto-configuration (SLAAC/DHCPv6)
In this section, the following parameters can be configured:
My IPv6 Connection is: Select the IPv6 Internet connection type that will be used
by this router. Options to choose from are Auto Detection, Static IPv6, Auto-
configuration (SLAAC/DHCPv6), PPPoE, IPv6 in IP4 Tunnel, 6to4, 6rd, and
Local Connectivity Only. In this section we’ll discuss the Auto-configuration
(SLAAC/DHCPv6) option.
In this section, the following parameters can be configured:
Obtain IPv6 DNS Servers automatically: Select this option to allow the router to
automatically obtain IPv6 DNS server IP addresses.
Use the following IPv6 DNS Server: Select this option to manually enter the IPv6
DNS server IP addresses.
Primary DNS Server: Enter the primary IPv6 DNS server address here.
Secondary DNS Server: Enter the secondary IPv6 DNS server address here.
To Next Page
Loading...
