Dual Band AC1750 Gigabit ADSL2+ Modem Router User Manual
Web User Interface Configuration Page 82
IPv6 Connection Type – PPPoE
In this section, the following parameters can be configured:
My IPv6 Connection is: Select the IPv6 Internet connection type that will be used
by this router. Options to choose from are Auto Detection, Static IPv6, Auto-
configuration (SLAAC/DHCPv6), PPPoE, IPv6 in IP4 Tunnel, 6to4, 6rd, and
Local Connectivity Only. In this section we’ll discuss the PPPoE option.
In this section, the following parameters can be configured:
PPPoE Session: Select the PPPoE session used here. To share this connection
with IPv4, select the Share with IPv4 option. To create a new connection,
select the Create a new session option.
Address Mode: Select the PPPoE address mode here. Options to choose from are
Dynamic IP and Static IP.
IP Address: After selecting the Static IP option as the address mode, enter the
static IPv6 address here.
User Name: Enter the IPv6 PPPoE username here.
Password: Enter the IPv6 PPPoE password here.
Verify Password: Enter the IPv6 PPPoE password here again to verify.
Service Name: Enter the service name here. This field is optional.
Reconnect Mode: Select this reconnect mode here. Options to choose from are
Always on, On demand, and Manual.
Maximum Idle Time: Enter the maximum idle time value here.
MTU: Enter the Maximum Transmission Unit (MTU) value here.
In this section, the following parameters can be configured:
Obtain IPv6 DNS Servers automatically: Select this option to allow the router to
automatically obtain IPv6 DNS server IP addresses.
Use the following IPv6 DNS Server: Select this option to manually enter the IPv6
DNS server IP addresses.
Primary DNS Server: Enter the primary IPv6 DNS server address here.
Secondary DNS Server: Enter the secondary IPv6 DNS server address here.
To Next Page
Loading...
