DSL-G2452GR AC1200 MU-MIMO Wireless Dual Band
VDSL2 Router with ADSL2+/3G/LTE/Gigabit Ethernet WAN
Support, 2 FXS Ports and USB Port
User Manual
Overview
LED Mode Description
INTERNET
Solid green
The default WAN connection is on.
Solid red
• The default WAN connection is off, or
• there are no WAN connections created.
No light
The router is being rebooted.
WAN
Solid green
The WAN cable is connected to the port.
Blinking green
Data transfer through the WAN port.
No light
The WAN cable is not connected.
LAN 1-4
Solid green
A device is connected to the port of the router (for the
LAN port configured as the WAN port: the router is
connected to an Ethernet line).
Blinking green
Data transfer through the relevant LAN port.
No light
The cable is not connected to the relevant port.
2.4GHz
5GHz
Solid green
The router's WLAN of the relevant band is on.
Blinking green
Data transfer through the Wi-Fi network of the relevant
band.
No light
The router's WLAN of the relevant band is off.
WPS
Blinking green
Attempting to add a wireless device via the WPS
function.
No light
The WPS function is not in use.
USB
Solid green
A USB device is connected to the router's USB port.
No light
No USB device.
FXS 1-2
Solid green
The phone is registered on the SIP server.
Blinking green
An attempt to register on the SIP server.
Fast blinking green
An incoming call or talking.
No light
The phone is not registered on the SIP server.
In case the INTERNET LED is fast blinking red, POWER, WPS, USB, and FXS 1-2 LEDs are
fast blinking green at the same time, the device is in the emergency mode. Power the device off and
on. If the device is loaded in the emergency mode again, restore the factory default settings via the
hardware RESET button.
Page 18 of 358
To Next Page
Loading...
