D-Link DSR-1000 - Page 15

Unified Services Router CLI Reference Guide
13
The command show security ? at the CLI prompt would give the description of all the show
commands in the branch security, which is as follows:
Sl No
Command Name
Purpose
1
show security attack_checks setup
Display Security Checks configuration
2
show security blocked_keywords setup
Display blocked keywords configuration
3
show security content_filtering setup
Display content filtering configuration
4
show security custom_service setup
Display Custom Service configuration
5
show security firewall ipv4 setup
Display Firewall Rules
6
show security firewall ipv6 setup
Display Firewall Rules
7
show security ids setup
Display IDS configuration
8
show security ip_or_mac_binding setup
Display IP/MAC Binding configuration
9
show security port_triggering setup
Display Port Triggering configuration
10
show security schedules setup
Display Schedules configuration
11
show security session_settings
Display Session Settings configuration
12
show security mac_filter setup
Display Source Mac Filter configuration
13
show security trusted_domains setup
Display trusted domains configuration
14
show security vpn_passthrough setup
Display VPN passthrough Configuration
The command show system ? at the CLI prompt would give the description of all the show
commands in the branch system, which is as follows:
Sl No
Command Name
Purpose
1
show system logging ipv6 setup
Display logging configuration
2
show system logging facility setup
Display logging facility configuration
3
show system logging ipv4 setup
Display logging configuration
4
show system radius setup
Display radius configuration
5
show system logging remote setup
Display remote logging configuration
6
show system remote_management setup
Display Remote Management configuration
7
show system snmp setup
Display snmp configuration
8
show system status
Display system status
9
show system time setup
Display timezone and ntp configuration
10
show system traffic_meter setup
Display traffic meter configuration
The command show dot11 ? at the CLI prompt would give the description of all the show
commands in the branch dot11, which is as follows:
Sl No
Command Name
Purpose
1
show dot11 access point setup [ap_name]
Display access point configuration
2
Show dot11 radio setup
Display radio configuration