Unified Services Router CLI Reference Guide
12
Chapter 5. Show commands used in
CLI
The show commands for all the above mentioned branches are outlined in this section.
The command show net ? at the CLI prompt would give the description of all the show
commands in the branch net, which is as follows:
show net available_lan_host list
Display available lan host list
show net bandwidth profile setup
Display bandwidth profile configuration
Display ddns configuration
show net dhcp leased_clients list
Display dhcp leased clients list
show net dhcp reserved_ip setup
Display dhcp reserved ip configuration
show net routing dynamic setup
Display dynamic routing configuration
Display network mode configuration
show net ipv6_tunnel setup
Display ipv6 tunnel’s configuration
Display ipv4 lan configuration
show net port management setup
Display port management configuration
Display radvd configuration
show net routing mode setup
Display routing mode configuration
show net routing static ipv4 setup
Display ipv4 static routes configuration
show net routing static ipv6 setup
Display ipv6 static routes configuration
Display network statistics
show net bandwidth traffic_selector setup
Display bandwidth traffic selector configurations
Display upnp configuration
show net wan wan1 ipv4 setup
Display ipv4 wan1 configuration
show net wan wan1 ipv4 status
Display ipv4 wan1 connection status
show net wan wan2 ipv4 setup
Display ipv4 wan2 configuration
Display ddns configuration for dedicated WAN and
configurable WAN
show net routing protocol_binding setup
Display protocol binding configuration
show net dmz dhcp reserved_ip setup
Display dhcp reserved ip configuration