D-Link DSR-1000 - Chapter 7. Configure Commands Used in CLI

Unified Services Router CLI Reference Guide
17
Chapter 7. Configure commands used
in CLI
The configure commands for all the branches mentioned above are discussed in this section.
The command net ? at the CLI prompt would give the description of all the configuration
commands in the branch net, which is as follows:
Sl No
Command Name
Purpose
1
net bandwidth profile add
It allows to add a bandwidth profile.
2
net bandwidth profile edit
It allows to edit a bandwidth profile.
3
net bandwidth profile delete
It allows to delete a bandwidth profile.
4
net ddns configure
Ddns configuration mode
5
net routing dynamic configure
Dynamic routing configuration mode
6
net mode configure
IP Mode configuration mode
7
net ipv6_tunnel isatap add
Isatap tunnel configuration mode.
8
net ipv6_tunnel isatap delete
Delete the configured isatap tunnel
9
net ipv6_tunnel isatap edit
Isatap tunnel configuration mode.
10
net ipv6_tunnel six_to_four automatic_tunneling
enable
Six to four tunnel configuration mode
11
net lan dhcp reserved_ip add
Dhcp reserved ip configuration mode
12
net lan dhcp reserved_ip delete
Delete the configured dhcp reserved ip
13
net lan ipv4 configure
Lan configuration mode
14
net lan ipv6 configure
Lan configuration mode
15
net lan ipv6 pool configure
Ipv6 pool configuration mode
17
net mld configure
MLD configuration mode
18
net port management configure
Port management configuration mode
19
net radvd configure
Radvd configuration mode
20
net radvd pool add
Radvd pool configuration add mode
21
net radvd pool delete
Radvd pool configuration delete mode
22
net radvd pool edit
Radvd pool configuration edit mode
23
net routing mode configure
Routing mode configuration
24
net routing static ipv4 configure
Static route configuration mode
25
net routing static ipv4 delete
Static route configuration delete mode
26
net routing static ipv6 configure
Static route configuration mode
27
net routing static ipv6 delete
Static route configuration delete mode
28
net bandwidth traffic_selector add
Traffic selector configuration mode