D-Link DSR-1000 - Page 23

Unified Services Router CLI Reference Guide
21
Sl No
Command Name
Purpose
30
vpn sslvpn users domains edit
Domains edit mode
31
vpn sslvpn users domains delete
Domains delete mode
32
vpn sslvpn users groups add
Groups add mode
33
vpn sslvpn users groups edit
Groups edit mode
34
vpn sslvpn users groups delete
Groups delete mode
35
vpn sslvpn users users ip_policies configure
Ip policies configure mode
36
vpn sslvpn users users ip_policies delete
Ip policies delete mode
37
vpn sslvpn users users browser_policies
Browser policies configuration mode
38
vpn sslvpn users users login_policies
Login policies configuration mode
The command dot11 ? at the CLI prompt would give the description of all the configuration
commands in the branch dot11, which is as follows:
Sl No
Command Name
Purpose
1
dot11 access point configure
802.11 access point configuration mode
2
dot11 access point delete
Delete an 802.11 access point.
3
dot11 access point disable
Disable an 802.11 access point.
4
dot11 access point enable
Enable an 802.11 access point.
5
dot11 access point mac add
Add a MAC Address to ACL List of an AP
6
dot11 access point mac delete
Delete a MAC Address from an ACL List of an AP.
7
dot11 radio advanced configure
802.11 advanced radio configuration mode.
8
dot11 radio configure
802.11 radio configuration mode.
9
dot11 profile configure
802.11 profile configuration mode.
10
dot11 profile delete
Delete an 802.11 profile.
Each of the above listed commands has in turn a set of sub-commands to fulfill the
requirements. The command – subcommand list is given in following sections.