16D-Link DWA-131 User Manual
Section 2 - Installation
Push Button Configuration (PBC)
To connect to your network using the WPS push button
configuration method, click the virtual button as shown in the
screenshot.
Note: You may also connect to your network by pressing the
WPS button on the adaper and holding for two seconds until the
wizard screen comes up. Then, press the WPS button on the
router/access point to continue.
Press the WPS button on your access point or wireless router
within 2 minutes to establish connectivity.
Select “Use the WiFi Proctected Setup (WPS)” to initiate the
configuration and click Next.
To Next Page
Loading...
