D-Link DWR-712

To Next Page

To Previous Page

41D-Link DWR-712 User Manual

Section 3 - Conguration

INBOUND FILTER SETTING

Select this box to Enable the lter.

Select a schedule to use and copy to the specied rule ID

when you click the Copy to button. You may select Always On

or use a specic schedule that you have dened. To create and

edit schedules, please refer to “Schedules” on page 55.

INBOUND FILTER RULES LIST

Here, you can select whether to Allow or Deny all incoming

trac except for trac that matches the listed rules.

This identies the rule.

Specify the local IP address and then specify the port after the

colon.

Specify the remote IP address and then the port after the

colon.

Tick the checkbox to enable the specied rule.

Specify the schedule rule number.

Go back to the previous lter page.

Advance to the next lter page.

Inbound Filter

Inbound Filter:

Use Schedule Rule:

ID:

Source IP : Ports:

Destination IP : Ports:

Enable:

Schedule Rule #:

Inbound Filter enables you to control what packets are allowed to come in to your network from the Internet. The inbound lter only applies to

packets that are destined for Virtual Servers or DMZ hosts. After modifying any settings, click Save Settings to save your changes.

Other manuals for D-Link DWR-712