CHAPTER-3
D-Link GLB-802C ADSL2+ Router User Manual 8
3.2 PREPARATIONS BEFORE ACCESSING THE ROUTER
Before accessing the GLB-802C ROUTER, make sure the communication between the PC and the
ROUTER are proper. Check the communication as follows:
1. Configure the IP address of the PC as 192.168.1.X (3~254), netmask as 255.255.255.0, gateway
address as 192.168.1.1(Ethernet connection) and gateway address as 192.168.1.2 (USB connection)
2. Use “arp -a” under DOS to check if the PC has learnt the MAC address of the ROUTER.
3.Ping the management IP address (192.168.1.1, when connected to the Ethernet port & 192.168.1.2,
when connected to the USB port) of the ROUTER. If the ping and the arp response is successful , it
indicates the connection between the router and the PC is proper.
3.3 WEB CONFIGURATION INTERFACE
When connected to the Ethernet port, open a web-browser enter http://192.168.1.1 (Router’s IP address)
in the address bar to access the Web GUI.
Enter the user name and password
Default setting:
IP address: 192.168.1.1
User name: admin
Password: admin
When connected to the USB port, open a web-browser enter http://192.168.1.2 (Router’s IP address) in
the address bar to access the Web GUI.
Enter the user name and password
Default setting:
IP address: 192.168.1.2
User name: admin
Password: admin
To Next Page
Loading...
