D-Link NUCLIAS CONNECT

26D-Link DAP-X2810 User Manual
11n Preferred: This function is only available when Connection Limit is enabled. Use the drop-down menu to enable the 11n
Preferred function. The wireless clients with 802.11n protocol will have higher priority to connect to the device.
Network Utilization: Click the drop-down menu to set the maximum utilization of this access point for service. The DAP-X2810 will not
allow any new clients to associate with the AP if the utilization exceeds the value the user species. When this network
utilization threshold is reached, the device will pause for one minute to allow network congestion to dissipate.
Aging out: Use the drop-down menu to select the criteria for disconnecting the wireless clients.
RSSI Threshold: When Aging out is RSSI, click the drop-down menu to select the percentage of RSSI. When the RSSI of wireless clients
is lower than the specied percentage, the device disconnects the wireless clients. The function is only available when
Aging out is RSSI.
Data Rate Threshold: When Aging out is Data Rate, click the drop-down menu to select the threshold of data rate. When the data rate of
wireless clients is lower than the specied number, the device disconnects the wireless clients. The function is only
available when Aging out is Data Rate.
ACL RSSI: Click the drop-down menu to enable the ACL RSSI function. When enabled, the device denies the connection request
from the wireless clients with the RSSI lower than the specied threshold below.
ACL RSSI Threshold: Click the drop-down menu to set the ACL RSSI Threshold.
Save: Click to save the updated conguration. To make the updates permanent, click Conguration > Save and Activate.