EasyManua.ls Logo

D-Link xStack DES-3526 - Page 123

D-Link xStack DES-3526
222 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
DES-3526 / DES-3526DC Layer 2 Fast Ethernet Switch CLI Reference Manual
120
config igmp_snooping querier
time it takes a router to detect the loss of the last member of a group.
state [enable | disable] Allows the Switch to be specified as an IGMP Querier or
Non-querier.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure IGMP snooping:
DES-3526:4#config igmp_snooping querier default query_interval 125 state enable
Command: config igmp_snooping querier default query_interval 125 state enable
Success.
DES-3526:4#
config router_ports
Purpose Used to configure ports as router ports.
Syntax
config router_ports <vlan_name 32> [add | delete] <portlist>
Description This command allows you to designate a range of ports as being
connected to multicast-enabled routers. This will ensure that all
packets with such a router as its destination will reach the multicast-
enabled router regardless of protocol, etc.
Parameters
<vlan_name 32> The name of the VLAN on which the router port
resides.
<portlist> Specifies a port or range of ports that will be configured
as router ports.
Restrictions Only administrator-level users can issue this command.
Example usage:
To set up static router ports:
DES-3526:4#config router_ports default add 1-10
Command: config router_ports default add 1-10
Success.
DES-3526:4#
enable igmp_snooping
Purpose Used to enable IGMP snooping on the Switch.
Syntax
enable igmp_snooping {forward_mcrouter_only}
Description This command allows you to enable IGMP snooping on the Switch. If
forward_mcrouter_only is specified, the Switch will only forward all
multicast traffic to the multicast router, only. Otherwise, the Switch
forwards all multicast traffic to any IP router.
Parameters
forward_mcrouter_only Specifies that the Switch should only
forward all multicast traffic to a multicast-enabled router. Otherwise,
the Switch will forward all multicast traffic to any IP router.
Restrictions Only administrator-level users can issue this command.

Related product manuals