DES-3526 / DES-3526DC Layer 2 Fast Ethernet Switch CLI Reference Manual
134
23
802.1X Commands
The DES-3526 implements the server-side of the IEEE 802.1x Port-based and MAC-based Network Access Control. This
mechanism is intended to allow only authorized users, or other network devices, access to network resources by establishing
criteria for each port on the Switch that a user or network device must meet before allowing that port to forward or receive frames.
Command Parameters
enable 802.1x
disable 802.1x
show 802.1x
auth_state
{ports <portlist>}
show 802.1x
auth_configuration
{ports <portlist>}
config 802.1x
capability ports
[<portlist> | all] [authenticator | none]
config 802.1x
auth_parameter
ports
[<portlist> | all] [default | {direction [both | in] | port_control [force_unauth |
auto | force_auth] | quiet_period <sec 0-65535> | tx_period <sec 1-
65535> | supp_timeout <sec 1-65535> | server_timeout <sec 1-65535> |
max_req <value 1-10> | reauth_period <sec 1-65535> | enable_reauth
[enable | disable]}]
config 802.1x
auth_protocol
[radius eap | radius pap]
config 802.1x init {port_based ports [<portlist> | all] | mac_based [ports] [<portlist> |all]
{mac_address <macaddr>}]
config 802.1x
auth_mode
[port_based | mac_based]
config 802.1x
reauth
{port_based ports [<portlist> | all] | mac_based [ports] [<portlist> |all]
{mac_address <macaddr>}]
config radius add <server_index 1-3> <server_ip> key <passwd 32> [default | {auth_port
<udp_port_number 1-65535> | acct_port <udp_port_number 1-65535>}]
config radius delete <server_index 1-3>
config radius <server_index 1-3> {ipaddress <server_ip> | key <passwd 32> [auth_port
<udp_port_number 1-65535> acct_port <udp_port_number 1-65535>]}
show radius
Each command is listed, in detail, in the following sections
enable 802.1x
Purpose Used to enable the 802.1x server on the Switch.
Syntax
enable 802.1x
Description The enable 802.1x command enables the 802.1x Network Access
control server application on the Switch. To select between port-based
or MAC-based, use the config 802.1x auth_mode command.
Parameters None.
Restrictions Only administrator-level users can issue this command.
Example usage:
To enable 802.1x switch wide:
To Next Page
Loading...
Need help?
General