D-Link xStack DES-3526 User Manual

DES-3526 / DES-3526DC Layer 2 Fast Ethernet Switch CLI Reference Manual
20
5
Switch Port Commands
The switch port commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
config ports [<portlist | all>] {speed [auto | 10_half | 10_full |100_half | 100_full | 1000_full]} |
flow_control [enable | disable] | learning [enable | disable] state [enable | disable]}
description <desc 32>}
show ports [<portlist>] {description}
Each command is listed, in detail, in the following sections.
config ports
Purpose
Used to configure the Switch’s Ethernet port settings.
Syntax config ports [<portlist | all>] {speed [auto | 10_half | 10_full |100_half | 100_full |
1000_full]} | flow_control [enable | disable] | learning [enable | disable] state [enable
| disable]} description <desc 32>}
Description
This command allows for the configuration of the Switch’s Ethernet ports. Only the ports
listed in the <portlist> will be affected.
Parameters
all − Configure all ports on the Switch.
<portlist> − Specifies a port or range of ports to be configured.
speed – Allows the user to adjust the speed for a port or range of ports. The user has a
choice of the following:
• auto − Enables auto-negotiation for the specified range of ports.
• [10 | 100 | 1000] − Configures the speed in Mbps for the specified range of
ports. Gigabit ports are statically set to 1000 and cannot be set to slower
speeds.
• [half | full] − Configures the specified range of ports as either full-duplex or half-
duplex.
flow_control [enable | disable] – Enable or disable flow control for the specified ports.
learning [enable | disable] − Enables or disables the MAC address learning on the
specified range of ports.
state [enable | disable] − Enables or disables the specified range of ports.
description <desc 32> - Enter an alphanumeric string of no more than 32 characters to
describe a selected port interface.
Restrictions
Only administrator-level users can issue this command.
Example usage:
To configure the speed of port 3 to be 10 Mbps, full duplex, with learning and state enabled:
DES-3526:4#config ports 1-3 speed 10_full learning enable state
enable
Command: config ports 1-3 speed 10_full learning enable state
enable
Success.
DES-3526:4#

D-Link xStack DES-3526 Specifications

General

Brand	D-Link
Model	xStack DES-3526
Category	Switch
Language	English