D-Link xStack DES-3526 - Page 24

DES-3526 / DES-3526DC Layer 2 Fast Ethernet Switch CLI Reference Manual
21
show ports
Purpose
Used to display the current configuration of a range of ports.
Syntax show ports [<portlist>] {description}
Description
This command is used to display the current configuration of a
range of ports.
Parameters
<portlist> − Specifies a port or range of ports to be displayed.
{description} – Adding this parameter to the show ports command
indicates that a previously entered port description will be included
in the display.
Restrictions
None.
Example usage:
To display the configuration of all ports on a standalone switch:
DES-3526:4#show ports
Command show ports:
Port Port Settings Connection Address
State Speed/Duplex/FlowCtrl Speed/Duplex/FlowCtrl Learning
------ -------- --------------------- --------------------- --------
1 Enabled Auto/Enabled Link Down Enabled
2 Enabled Auto/Enabled Link Down Enabled
3 Enabled Auto/Enabled Link Down Enabled
4 Enabled Auto/Enabled Link Down Enabled
5 Enabled Auto/Enabled Link Down Enabled
6 Enabled Auto/Enabled Link Down Enabled
7 Enabled Auto/Enabled Link Down Enabled
8 Enabled Auto/Enabled Link Down Enabled
9 Enabled Auto/Enabled Link Down Enabled
10 Enabled Auto/Enabled 100M/Full/None Enabled
11 Enabled Auto/Enabled Link Down Enabled
12 Enabled Auto/Enabled Link Down Enabled
13 Enabled Auto/Disabled Link Down Enabled
14 Enabled Auto/Disabled Link Down Enabled
15 Enabled Auto/Disabled Link Down Enabled
16 Enabled Auto/Disabled Link Down Enabled
17 Enabled Auto/Disabled Link Down Enabled
18 Enabled Auto/Disabled Link Down Enabled
19 Enabled Auto/Disabled Link Down Enabled
20 Enabled Auto/Disabled Link Down Enabled
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh