DES-3526 / DES-3526DC Layer 2 Fast Ethernet Switch CLI Reference Manual
143
config radius
Purpose Used to configure the Switch’s RADIUS settings.
Syntax
config radius <server_index 1-3> {ipaddress <server_ip> | key
<passwd 32> | auth_port <udp_port_number 1-65535> |
acct_port <udp_port_number 1-65535>}
Description The config radius command is used to configure the Switch’s
Radius settings.
Parameters
<server_index 1-3> − Assigns a number to the current set of
RADIUS server settings. Up to 3 groups of RADIUS server settings
can be entered on the Switch.
ipaddress <server_ip> − The IP address of the RADIUS server.
key − Specifies that a password and encryption key will be used
between the Switch and the RADIUS server.
• <passwd 32> − The shared-secret key used by the
RADIUS server and the Switch. Up to 32 characters can
be used.
auth_port <udp_port_number 1-65535> − The UDP port number for
authentication requests. The default is 1812.
acct_port <udp_port_number 1-65535> − The UDP port number for
accounting requests. The default is 1813.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure the RADIUS settings:
DES-3526:4#config radius 1 10.48.74.121 key dlink default
Command: config radius 1 10.48.74.121 key dlink default
Success.
DES-3526:4#
show radius
Purpose Used to display the current RADIUS configurations on the Switch.
Syntax
show radius
Description The show radius command is used to display the current RADIUS
configurations on the Switch.
Parameters None.
Restrictions None.
Example usage:
To display RADIUS settings on the Switch:
To Next Page
Loading...
Need help?
General