DES-3526 / DES-3526DC Layer 2 Fast Ethernet Switch CLI Reference Manual
188
config authen server_group
add/delete – Enter the correct parameter to add or delete a server host
from a server group.
server_host <ipaddr> - Enter the IP address of the previously configured
server host to add or delete.
protocol – Enter the protocol utilized by the server host. There are three
options:
tacacs – Use this parameter to define the protocol if the server
host is using the TACACS authentication protocol.
xtacacs – Use this parameter to define the protocol if the server
host is using the XTACACS authentication protocol.
tacacs+ – Use this parameter to define the protocol if the server
host is using the TACACS+ authentication protocol.
radius – Use this parameter to define the protocol if the server
host is using the RADIUS authentication protocol.
Restrictions Only administrator-level users can issue this command.
Example usage:
To add an authentication host to server group “group_1”:
DES-3526:4# config authen server_group group_1 add server_host
10.1.1.121 protocol tacacs+
Command: config authen server_group group_1 add server_host
10.1.1.121 protocol tacacs+
Success.
DES-3526:4#
delete authen server_group
Purpose Used to delete a user-defined authentication server group.
Syntax
delete authen server_group <string 15>
Description This command will delete an authentication server group.
Parameters <string 15> - Enter an alphanumeric string of up to 15 characters to
define the previously created server group to be deleted.
Restrictions Only administrator-level users can issue this command.
Example usage:
To delete the server group “group_1”:
DES-3526:4#delete server_group group_1
Command: delete server_group group_1
Success.
DES-3526:4#
To Next Page
Loading...
