D-Link xStack DES-3526 - System Configuration and Reboot

DES-3526 / DES-3526DC Layer 2 Fast Ethernet Switch CLI Reference Manual
17
DES-3526:4#enable web 80
Command: enable web 80
Success.
DES-3526:4#
disable web
Purpose
Used to disable the HTTP-based management software on the
Switch.
Syntax disable web
Description
This command disables the Web-based management software on
the Switch.
Parameters
None.
Restrictions
Only administrator-level users can issue this command.
Example usage:
To disable HTTP:
DES-3526:4#disable web
Command: disable web
Success.
DES-3526:4#
save
Purpose
Used to save changes in the Switch’s configuration to non-volatile
RAM.
Syntax save
Description
This command is used to enter the current switch configuration into
non-volatile RAM. The saved switch configuration will be loaded into
the Switch’s memory each time the Switch is restarted.
Parameters
None
Restrictions
Only administrator-level users can issue this command.
Example usage:
To save the Switch’s current configuration to non-volatile RAM:
DES-3526:4#save
Command: save
Saving all configurations to NV-RAM... Done.
DES-3526:4#