DES-3526 / DES-3526DC Layer 2 Fast Ethernet Switch CLI Reference Manual
208
DES-3526:4#disable sim
Command: disable sim
Success.
DES-3526:4#
show sim
Purpose Used to view the current information regarding the SIM group on the
Switch.
Syntax
show sim {[candidates {<candidate_id 1-32>} | members
{<member_id 1-32> } | group {commander_mac <macaddr>}] |
neighbor]}
Description This command will display the current information regarding the SIM
group on the Switch, including the following:
SIM Version - Displays the current Single IP Management version on
the Switch.
Firmware Version - Displays the current Firmware version on the
Switch.
Device Name - Displays the user-defined device name on the Switch.
MAC Address - Displays the MAC Address of the Switch.
Capabilities – Displays the type of switch, be it Layer 2 (L2) or Layer 3
(L3).
Platform – Switch Description including name and model number.
SIM State –Displays the current Single IP Management State of the
Switch, whether it be enabled or disabled.
Role State – Displays the current role the Switch is taking, including
Commander, Member or Candidate. A Stand-alone switch will always
have the commander role.
Discovery Interval - Time in seconds the Switch will send discovery
packets out over the network.
Hold time – Displays the time in seconds the Switch will hold discovery
results before dropping it or utilizing it.
Parameters candidates <candidate_id 1-32> - Entering this parameter will display
information concerning candidates of the SIM group. To view a specific
candidate, include that candidate’s ID number, listed from 1 to 32.
members <member_id 1-32> - Entering this parameter will display
information concerning members of the SIM group. To view a specific
member, include that member’s id number, listed from 1 to 32.
group {commander_mac <macaddr>} - Entering this parameter will
display information concerning the SIM group. To view a specific
group, include the commander’s MAC address of the group.
neighbor – Entering this parameter will display neighboring devices of
the Switch. A SIM neighbor is defined as a switch that is physically
connected to the Switch but is not part of the SIM group. This screen
will produce the following results:
Port – Displays the physical port number of the commander
switch where the uplink to the neighbor switch is located.
MAC Address – Displays the MAC Address of the neighbor
switch.
Role – Displays the role(CS, CaS, MS) of the neighbor switch.
Restrictions None.
Example usage:
To Next Page
Loading...
