DES-3526 / DES-3526DC Layer 2 Fast Ethernet Switch CLI Reference Manual
27
Command Parameters
create snmp user <username 32> <groupname 32> {encrypted [by_password
auth [md5 <auth_password 8-16 > | sha <auth_password 8-20
>] priv [none | des <priv_password 8-16> ] | by_key auth [md5
<auth_key 32-32> | sha <auth_key 40-40>] priv [none | des
<priv_key 32-32>]]}
delete snmp user <SNMP_name 32>
show snmp user
create snmp view <view_name 32> <oid> view_type [included | excluded]
delete snmp view <view_name 32> [all | oid]
show snmp view <view_name 32>
create snmp community <community_string 32> view <view_name 32> [read_only |
read_write]
delete snmp community <community_string 32>
show snmp community <community_string 32>
config snmp engineID <snmp_engineID>
show snmp engineID
create snmp group <groupname 32> {v1 | v2c | v3 [noauth_nopriv | auth_nopriv |
auth_priv]} {read_view <view_name 32> | write_view
<view_name 32> | notify_view <view_name 32>}
delete snmp group <groupname 32>
show snmp groups
create snmp host <ipaddr> {v1 | v2c | v3 [noauth_nopriv | auth_nopriv | auth_priv]}
<auth_string 32>
delete snmp host <ipaddr>
show snmp host <ipaddr>
create trusted_host <ipaddr>
delete trusted_host <ipaddr>
show trusted_host <ipaddr>
enable snmp traps
enable snmp authenticate_traps
show snmp traps
disable snmp traps
disable snmp authenticate_traps
config snmp system contact <sw_contact>
config snmp system location <sw_location>
config snmp system name <sw_name>
enable rmon
disable rmon
Each command is listed, in detail, in the following sections.
To Next Page
Loading...
Need help?
General