D-Link xStack DES-3526 - Page 36

DES-3526 / DES-3526DC Layer 2 Fast Ethernet Switch CLI Reference Manual
33
show snmp community
Purpose Used to display SNMP community strings configured on the Switch.
Syntax
show snmp community {<community_string 32>}
Description The show snmp community command is used to display SNMP
community strings that are configured on the Switch.
Parameters
<community_string 32> − An alphanumeric string of up to 32
characters that is used to identify members of an SNMP community.
This string is used like a password to give remote SNMP managers
access to MIB objects in the Switch’s SNMP agent.
Restrictions None.
Example usage:
To display the currently entered SNMP community strings:
DES-3526:4#show snmp community
Command: show snmp community
SNMP Community Table
Community Name View Name Access Right
-------------------------------- ------------------------------- ------------
dlink ReadView read_write
private CommunityView read_write
public CommunityView read_only
Total Entries: 3
DES-3526:4#
config snmp engineID
Purpose Used to configure a name for the SNMP engine on the Switch.
Syntax
config snmp engineID <snmp_engineID>
Description The config snmp engineID command configures a name for the
SNMP engine on the Switch.
Parameters
<snmp_engineID> − An alphanumeric string that will be used to
identify the SNMP engine on the Switch.
Restrictions Only administrator-level users can issue this command.
Example usage:
To give the SNMP agent on the Switch the name “0035636666”
DES-3526:4#config snmp 0035636666
Command: config snmp engineID 0035636666
Success.
DES-3526:4#