DES-3526 / DES-3526DC Layer 2 Fast Ethernet Switch CLI Reference Manual
39
create trusted_host
Purpose Used to create the trusted host.
Syntax
create trusted_host <ipaddr>
Description The create trusted_host command creates the trusted host. The
Switch allows you to specify up to four IP addresses that are allowed
to manage the Switch via in-band SNMP or TELNET based
management software. These IP addresses must be members of the
Management VLAN. If no IP addresses are specified, then there is
nothing to prevent any IP address from accessing the Switch,
provided the user knows the Username and Password.
Parameters
<ipaddr> − The IP address of the trusted host to be created.
Restrictions Only administrator-level users can issue this command.
Example usage:
To create the trusted host:
DES-3526:4#create trusted_host 10.48.74.121
Command: create trusted_host 10.48.74.121
Success.
DES-3526:4#
show trusted_host
Purpose Used to display a list of trusted hosts entered on the Switch using
the create trusted_host command above.
Syntax
show trusted_host <ipaddr>
Description This command is used to display a list of trusted hosts entered on
the Switch using the create trusted_host command above.
Parameters
<ipaddr> − The IP address of the trusted host.
Restrictions None.
Example Usage:
To display the list of trust hosts:
DES-3526:4#show trusted_host
Command: show trusted_host
Management Stations
IP Address
-----------------------
10.53.13.94
Total Entries: 1
DES-3526:4#
To Next Page
Loading...
