DES-3526 / DES-3526DC Layer 2 Fast Ethernet Switch CLI Reference Manual
42
disable snmp authenticate_traps
Purpose Used to disable SNMP authentication trap support.
Syntax
disable snmp authenticate_traps
Description This command is used to disable SNMP authentication support on
the Switch.
Parameters None.
Restrictions Only administrator-level users can issue this command.
Example Usage:
To disable the SNMP authentication trap support:
DES-3526:4#disable snmp authenticate_traps
Command: disable snmp authenticate_traps
Success.
DES-3526:4#
config snmp system_contact
Purpose Used to enter the name of a contact person who is responsible for
the Switch.
Syntax
config snmp system_contact{<sw_contact>}
Description The config snmp system_contact command is used to enter the
name and/or other information to identify a contact person who is
responsible for the Switch. A maximum of 255 character can be
used.
Parameters <sw_contact> - A maximum of 255 characters is allowed. A NULL
string is accepted if there is no contact.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure the Switch contact to “
MIS Department II
”:
DES-3526:4#config snmp system_contact MIS Department II
Command: config snmp system_contact MIS Department II
Success.
DES-3526:4#
config snmp system_location
Purpose Used to enter a description of the location of the Switch.
Syntax
config snmp system_location {<sw_location>}
Description The config snmp system_location command is used to enter a
description of the location of the Switch. A maximum of 255
characters can be used.
Parameters <sw_location> - A maximum of 255 characters is allowed. A NULL
string is accepted if there is no location desired.
Restrictions Only administrator-level users can issue this command.
To Next Page
Loading...
