DES-3526 / DES-3526DC Layer 2 Fast Ethernet Switch CLI Reference Manual
47
To configure firmware section 1 as a boot up section:
DES-3526:4# config firmware section_id 1 boot_up
Command: config firmware section_id 1 boot_up
Success.
DES-3526:4#
show firmware information
Purpose Used to display the firmware section information.
Syntax
show firmware information
Description This command is used to display the firmware section information
Parameters None.
Restrictions None
Example usage:
To display the current firmware information on the Switch:
DES-3526:4#show firmware information
Command: show firmware information
ID Version Size(B) Update Time From User
-- -------- ------- ------------------- ------------------ ---------------
1 2.00-B19 1360471 00000 days 00:00:00 Serial Port (PROM) Unknown
*2 1.00-B21 2052372 00000 days 00:00:56 10.53.13.94 Anonymous
'*' means boot up section
(T) means firmware update thru TELNET
(S) means firmware update thru SNMP
(W) means firmware update thru WEB
Free space: 3145728 bytes
DES-3526:4#
show config
Purpose Used to display the current or saved version of the configuration settings of the
switch.
Syntax
show config [current_config | config_in_nvram]
Description Use this command to display all the configuration settings that are saved to NV
RAM or display the configuration settings as they are currently configured. Use the
keyboard to list settings one line at a time (Enter), one page at a time (Space) or
view all (a).
The configuration settings are listed by category in the following order:
To Next Page
Loading...
Need help?
General