DES-3526 / DES-3526DC Layer 2 Fast Ethernet Switch CLI Reference Manual
86
show traffic control
Purpose Used to display current traffic control settings.
Syntax
show traffic control {group_list <storm_grouplist>}
Description This command displays the current storm traffic control configuration
on the Switch.
Parameters
group_list <storm_grouplist> − Used to specify a broadcast storm
control group. This is specified by entering the syntax unit_id.
Restrictions None.
Example usage:
To display traffic control setting:
DES-3526:4#show traffic control
Command: show traffic control
Traffic Control
Broadcast Multicast Destination
Module Group [ports] Threshold Storm Storm Lookup Fail
------ ------------- --------- --------- --------- --------
1 1 [ 1-8 ] 128 Disabled Disabled Disabled
1 2 [ 9-18 ] 128 Disabled Disabled Disabled
1 3 [ 17-24] 128 Disabled Disabled Disabled
1 4 [ 25 ] 128 Disabled Disabled Disabled
1 5 [ 26 ] 128 Disabled Disabled Disabled
Total Entries: 5
DES-3526:4#
To Next Page
Loading...
