DES-3526 / DES-3526DC Layer 2 Fast Ethernet Switch CLI Reference Manual
88
config bandwidth_control
tx_rate − Specifies that one of the parameters below (no_limit or
<value 1-1000>) will be applied to the rate at which the above
specified ports will be allowed to transmit packets.
no_limit − Specifies that there will be no limit on the rate of
packets received by the above specified ports.
<value 1-1000> − Specifies the packet limit, in Mbits, that the
above ports will be allowed to receive.
The transfer(tx) and receive(rx) rate of packets for Gigabit ports must
be configured in a multiple of 8 Mbits. (8, 16, 24…)
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure bandwidth control:
DES-3526:4#config bandwidth_control 1-10 tx_rate 10
Command: config bandwidth_control 1-10 tx_rate 10
Success.
DES-3526:4#
show bandwidth_control
Purpose Used to display the bandwidth control table.
Syntax
show
bandwidth_control {<portlist>}
Description The show bandwidth_control command displays the current
bandwidth control configuration on the Switch, on a port-by-port
basis.
Parameters
<portlist> − Specifies a port or range of ports to be viewed.
Restrictions None.
Example usage:
To display bandwidth control settings:
DES-3526:4#show bandwidth_control 1-10
Command: show bandwidth_control 1-10
Bandwidth Control Table
Port RX Rate (Mbit/sec) TX_RATE (Mbit/sec)
---- ------------------------ ----------------------
1 no_limit 10
2 no_limit 10
3 no_limit 10
4 no_limit 10
5 no_limit 10
6 no_limit 10
7 no_limit 10
8 no_limit 10
9 no_limit 10
10 no_limit 10
DES-3526:4#
To Next Page
Loading...
