TYRE PRESSURE MONITORING SYSTEM
3
Message display
The table below shows the possible messages related to the tyre resetting procedure.
Steps Displays
(depending on the ve-
hicle)
Readings
1 With the ignition on and the vehicle stationary, start resetting the pressure of all four tyres by
pressing and holding the
4
OK switch.
2 The "---" symbols in front of each wheel will flash to indicate that the system has registered
the tyre pressure reset for all four wheels.
3 The "---" symbols in front of each wheel will remain lit. This system resets the tyre pressure of
all four tyres. You can now drive. The message may remain displayed during short journeys.
Note: during the reset, tyre pressure monitoring remains in operation.
4 The pressure value of the four tyres is displayed: the resetting procedure is complete and
successful.
172 - Driving
To Next Page
Loading...
