Polaris 1000 User’s Manual
Page 13
2.3 Mounting Procedure
(1) The Polaris is wall-mounted, drill the screw holes according to the diagram
below.
(2) Place the Polaris flat against the wall making sure that the mounting holes are
aligned with the screw holes.
(3) Secure the Polaris using the screws through the mount holes.
2.4 Before Installation
(1) Check that the ratings and specifications of the model to be installed is
suitable for its intended application.
(2) Verify that the dedicated CT being used is compatible with the type of Polaris.
Note that the Polaris cannot be directly used with non-DAE dedicated CTs.
(3) Verify that the current rating of the dedicated CT being used is suitable for its
intended load.
(4) Make sure to turn off all power sources to the Polaris and any adjacent power
sources before performing the installation.
To Next Page
Loading...
