40
<CLEANING BATTERY TERMINALS>
●If you remove two screws from battery
box cover after putting floor panel met
forward, you will find battery assembled.
●If the battery terminal is polluted, or in
rust, separate battery and clean it.
●Battery terminal in rust with white
powder should be cleaned with warm
water.
●In case of serious rust of battery ter-
minal, disassemble the battery cord and
grind it with wirebrush or sandpaper.
<REPLENISHING BATTERY WATER>
●This vehicle doesn’t need either
replenishing or checking battery water
because of the equipment of enclosed
MF battery.
●In case battery needs a checking, it
should be cared of by service center.
BATTERY COVER
BATTERY INSPECTION
CAUTION
●Turn the ignition switch OFF
before disconnecting the terminal
from the battery. Remove the
negative pole side cord first and
the positive pole side cord next.
Make sure, at this time, that
side cord is connected first,
followed by side cord.
●When handling the battery stay
away from flammable materials.
●Make sure that terminals do not
contact with other adjacent parts
when handling / terminal.
Contact with other parts may cause
spark resulting in electrical equip-
ment malfunction, fire and electric
shock.
●Frequent cell starting can shorten
the battery lifetime. Please use a
kick to start the engine after the
long period storage and in case of
the initial starting and the cold
starting to improve starting
performance and extend the battery
lifetime.
CAUTION
●Be careful not to disassemble in-
jection part of enclosed battery.
●When not using vehicle during a
long time, take off the battery from
the vehicle to keep from self-
discharge and electric discharge.
Put the battery in a well ventilated
place after charging fully. In case it
isn’t available to take battery off
from the vehicle, disconnect “-”
terminal.
*NS-125DLXO/M 02.11.5 3:41 PM 페이지40
To Next Page
Loading...
Need help?
General
