DAELIM NS 125 DLX User Manual

42
●Be sure to turn the ignition switch
OFF when replacing the bulb.
●Do not use bulbs other than that
specified.
●After installing a new bulb, check that
the light operates properly.
[HEADLIGHT BULB]
●Before replacing the bulb, be sure to
check the switches for loose
connection of the connector.
① Loosen the special screw and remove
the front cover.
② Loosen the 4 headlight setting bolts
and pull off the socket without turning.
③ Remove the rubber cover.
④ Remove the pin.
⑤ Slightly press down on the bulb and
turn it counterclockwise.
⑥ Install a new bulb in the reverse order
of removal.
HEADLIGHT BULB : 12V35/35W
CAUTION
●The light bulb becomes very hot
while the light is ON, and remain
hot for a while after it is turned
OFF. Be sure to let it cool down
before servicing.
●Do not put finger prints on the
headlight bulb, as they may create
hot spots on the bulb and cause it to
break. Wear clean gloves while
replacing the bulb.
If you touch the bulb with your
bare hands, clean it with a cloth
moistened with alcohol to prevent
its early failure.
FRONT COVER
HEADLIGHT
BULB
HEAD LIGHT
RUBBER COVER
BULB REPLACEMENT
*NS-125DLXO/M 02.11.5 3:41 PM 페이지42

DAELIM NS 125 DLX Specifications

General

Brand	DAELIM
Model	NS 125 DLX
Category	Scooter
Language	English