Need help?Do you have a question about the DAELIM NS125DLX and is the answer not in the manual?
Critical safety precautions for operation and maintenance.
Key technical data and measurements for the vehicle.
Specific torque settings for critical assembly points.
Guidelines for proper routing of wires and cables.
Safety precautions related to lubrication and fluid handling.
Information on engine oil type, capacity, and recommendation.
Procedure for replacing the oil filter element.
Maintenance schedule based on odometer readings and time.
Inspection and replacement procedures for the spark plug.
Procedure for checking and adjusting valve clearance.
Steps to adjust the engine's idle speed.
Overview of frame cover disassembly order.
Steps for removing and installing the front cover.
Procedure for removing and installing the luggage box.
Safety precautions when working with the fuel system.
Procedure for removing and installing the fuel tank.
Removal and disassembly steps for the carburetor.
Safety precautions when removing or installing the engine.
Step-by-step instructions for removing the engine assembly.
Safety precautions for drive belt and pulley handling.
Key measurements for transmission components.
Common issues and causes related to this section.
Removal and installation of the A.C. generator.
Removal and inspection of the starter clutch.
Technical data for cylinder head and valve components.
Steps to remove the camshaft.
Procedure for removing the cylinder head.
Common problems with cylinder and piston.
Removal and inspection of the cylinder.
Disassembly and inspection of the piston.
Safety precautions for crank case and transmission work.
Common issues and causes related to transmission and crank case.
Steps to disassemble the crankshaft.
Safety precautions for wheel, fork, and steering system.
Common problems with steering and suspension.
Procedure for removing and installing the steering handle.
Steps for removing and installing the front wheel.
Safety precautions for brake and suspension components.
Common issues with rear wheel and suspension.
Procedure for removing and installing the rear wheel.
Safety precautions when working with brake fluid.
Common problems related to braking performance.
Steps for changing and bleeding brake fluid.
Procedure for replacing brake pads.
Safety precautions for battery and charging system.
Common issues with the charging system and battery.
Procedures for battery inspection and replacement.
Safety precautions for ignition system service.
Common problems related to ignition system.
Steps to inspect the ignition coil.
Specifications for starter motor components.
Common problems with the starter motor.
Safety precautions for electrical system components.
Common issues with lights, switches, and horn.
Bulb replacement and removal procedures for the headlight.
Electrical schematic showing component connections and wire colors.
Diagnostic steps for engine starting issues.
Diagnostic steps for low engine power or performance.
Troubleshooting steps for starter motor problems.
To Next Page
General
