DAELIM NS125DLX - Steering Handle

Front Wheel/Front Fork/Steering
Steering Handle
Removal
 Remove the following parts.
- Back mirror
- Front cover ( 4-3)
- LH. RH. Front handle side cover
- Front handle cover
-Remove the speedometer cable from the
speedometer.
- Rear handle cover
 Loosen the front master cylinder holder bolts,
remove the front master cylinder.
 Loosen the rear master cylinder holder bolts,
remove the rear master cylinder.
CAUTION
Support master cylinders properly to prevent
brake fluid from leaking
If the master cylinders are dropped upside down,
air may enter the hydraulic system. Fix it to the
vehicle while maintaining the correct assembled
location.
 Loosen the throttle housing fixing screw, remove
the upper/under housing.
 Remove the throttle cable from the throttle grip,
remove the throttle grip from the steering handle.
 Remove the FR./RR. brake hose, speedometer
cable, throttle cable from the handle cable guide.
 Loosen the handle setting bolt and U-nut.
 Remove the steering handle from the steering
stem.
Installation
 Install the steering handle to the steering stem.
 Install the handle setting bolt and U-nut.
Torque values: 5.0kgf
m(50N.m, 36ft-lb)
NOTE
When installing the handle setting collar, match it
with the groove accurately.
12-3
Screw
Front master cylinder
Trottle grip
Rear master cylinder
Upper/under housing
Setting bolt