DAELIM NS125DLX - Front Wheel

Front Wheel/Front Fork/Steering
 Insert the brake cable, speedometer cable, throttle
cable into the handle cable guide.

Install the rear handle cover to the steering handle.
 Connect the speedometer cable, and tighten cable
nut completely.

Lift the front handle cover, and connect the winker
wiring.
 Insert the front handle cover into the rear handle
cover joint (hook type), and tighten with screws.
NOTE
 Install the LH. RH. front handle side cover.
 Install the front cover. ( 4-3)
 Install the back mirror.
Front Wheel
Removal
 Loosen axle nut. Support bottom of engine with a
Jack until the front wheel is lifted
 Remove screw from the speedometer gear box,
and separate the speedometer cable. Remove axle
nut, front axle, and front wheel.
NOTE
12-5
 Make sure the front wiring is not interfered with.
 Do not operate brake lever after the front wheel
is removed.
Rear handle cover
Front handle cover
Speedometer cable
Speedometer gear box
Axle nut
Screw