43
[TAIL/STOPLIGHT BULB]
① Remove the rear undercover.
② Loosen the 2 screws and remove the
rear combination light lens.
③ Slightly press down on the bulb and
turn it counterclockwise.
④ Install a new bulb in the reverse order
of removal.
TAIL/STOP LIGHT BULB : 12V 21W/5W
[WINKER BULB]
<FRONT WINKER BULB>
① Remove the RH./LH. back mirrior.
② Loosen the 1 RH./LH. handle side
cover lower screw, and 1 each of the
special upper side screws.
③ Loosen the 4 rear handle cover screws.
④ Loosen the front handle cover setting
screw.
⑤ Pull the front handle cover foward, and
remove the wiring.
⑥ Remove the front handle cover.
⑦ Loosen the screw and remove the
socket.
⑧ Slightly press down on the bulb and
turn it counterclockwise.
⑨ Install a new bulb in the reverse order
of removal.
FRONT WINKER BULB : 12V 10W
BULB
REAR UNDERCOVER
RH. BACK MIRRIOR
LH. BACK
MIRRIOR
BULB
SOCKET
SCREW
FRONT HANDLE
COVER
LH. HANDLE
SIDE COVER
FRONT HANDLE
COVER
RH. HANDIE
SIDE COVER
REAR COMBINATION
LIGHT LENS
*NS-125DLXO/M 02.11.5 3:41 PM 페이지43
To Next Page
Loading...
Need help?
General
