3
-
27
DEVICE CONTROL TIPS
Seat Belt Warning Lamp
The lamp turns on when the driver is not
wearing the seat belt.
If the driver is not wearing the seat belt
after the main switch has been moved to
the “ON”position, the alarm sounds and the warning lamp
light up in the instrument panel.
Although the alarm stops when the driver starts the engine
without wearing the seat belt, the warning lamp in the
instrument panel remains continuously turned on.
Engine Coolant Warning Lamp
The warning lamp turns on and the
alarm sounds when the vehicle has
insufficient coolant or when the coolant’s
temperature is over 98℃.
Check the temperature indicator in the instrument panel and
if the temperature has risen over the red zone, park your
vehicle on the lane and maintain the engine station speed at
the idle speed while continuously having the engine operate.
Engine Oil Pressure Warning Lamp
The lamp turns on when the battery
main switch is in the “ON”position, and
turns off when the engine starts and the
engine oil pressure reaches over the
suggested level (0.6 kg/cm
2
).
The lamp turns on and the alarm sounds when the vehicle
has insufficient engine oil or when there’s a drop in the oil
pressure.
Upon such incident, park the vehicle on a flat road, turn of
the engine, wait for about 10 minutes, and check the amount
of engine oil by observing the engine oil level gauge. If it
indicates insufficiency, supplement your engine oil.
OM-B377
OM-B421
OM-B365
CAUTION
If the vehicle’s engine coolant thermometer indicates high
temperature, always wait until the coolant cools down
while continuously having the engine operate.
WARNING
If you continue to drive while the oil pressure warning
indication is on, it will result in critical damages in engine
system.
You must park the vehicle and check the oil level before
visiting a nearest service center.
To Next Page
