- 91 -
Oil Drain Pipe
1) Disassemble the exhaust manifold spacer
which it is just bottom of the torbo charger
part so as to be easily set up oil drain pipe.
2) Tighten the flange nut as it is the specified
torque after it is assemble oil return pipe.
3) Tighten it as it is specified torque after
reinstalled the exhaust manifold spacer tube.
(See page 71)
Oil Feed Pipe
1) Pre-lubricate turbo charger with CD grade oil
through the oil port shown by the arrow in
the illustration.
2) Tighten flange bolt as it is a specified torque
after it is assemble oil delivey pipe.
EJM2158S
EJM2159S
Oil drain pipe torque 3.8±0.7 kg∙m
Oil return pipe bolt torque
2.6±0.5 kg∙m
Spacer
Tube
To Next Page
Loading...
