19
SETUP
4
Press [ENTER]. The ‘Manual Setup’ menu
appears.
5
Use […/†] to select ‘Standard‘. Press [ENTER]
to move to the second level.
6
Use […/†] to select the desired ‘Standard’
(PAL-BG, PAL-II, PAL-DK, or SECAM-L), then
press [ENTER].
7
Use […/†] to select ‘Reception‘. Press
[ENTER] to move to the second level.
8
Use […/†] to select the desired broadcast
system (Aerial or Cable), then press [ENTER].
Aerial:
If you are using a standard antenna to
receive channels.
Cable:
If you are using basic cable to receive
channels.
Installation
Manual Set
Auto Set
Set Clock
Adjust Channels
Instructions
Enter-Confirm Setup-Exit
Move
…†
Manual Setup
Standard PAL-BG
Reception Aerial
Auto Search CH-02
Fine Tune
Decoder Off
Store Channel PR01
Program Name P-01
Instructions
Enter-Confirm Setup-Exit Move …†
Select The
standard.
PAL-BG
PAL-II
PAL-DK
SECAM-L
Manual Setup
Standard PAL-BG
Reception Aerial
Auto Search CH-02
Fine Tune
Decoder Off
Store Channel PR01
Program Name P-01
Instructions
Enter-Confirm Setup-Exit Move …†
Select The
Reception.
Aerial
Cable
This set is equipped with the Multi-Tuner. You can
search broadcasting of other countries. If the set
can not search the channels, please Re-Install. (see
page 18.)
The HDD/DVD Recorder Setup menu includes six
categories, including: Installation, Recording
Options, Languages, Preferences, System Info, and
Restore Defaults. Press [SETUP] and [
œ/√] on the
remote control to view the first and second levels of
the Setup menu.
Setup Menu Overview
Setup menu
Setup menu
1
Press [SETUP]. The Setup menu appears.
2
Use [œ/√] to select the desired category.
3
While the desired category is selected, press
[
…/†] to move to the second level.
4
Press [ENTER] to move to the third level.
5
Use […/†] to select the desired setting, then
press [ENTER] to confirm your selection.
Some items require additional steps. Press
[SETUP] at any time to return to the previous
menu.
6
Press [SETUP] to exit the Setup menu.
Menu Navigation
Manual Set
To complete the set-up of your HDD/DVD Recorder
when the auto set has not stored all of the channels
or when you wish to store a new channel.
1
Press [SETUP]. The Setup menu appears.
2
Use [œ/√] to select ‘Installation‘.
3
While ‘Installation‘ is selected, press [†] to
select ‘Manual Set‘.
INSTALLATION Settings
DG-M12D1P-SA(GB) 2005.11.1 11:27 AM ˘ ` 19 mac001 1200DPI 100LPI
To Next Page
Loading...
