14
TROUBLE SHOOTING
CONCERNING NO DRAINING
Act normally
Exist
Set rinse or spin. Start the machine.
Measure the voltage of the two
ends of the drain puller
Measure the voltage of the two ends of
the output of the computer sequencer.
Replace the drain puller.
Check if the drain puller acts.
Check the drain system like the drain valve ect.
No
Not exist
Not exist
Replace the computer sequencer.
Yes
Yes
Yes
Yes
Yes
Open the water faucet without switching on the power.
If the water can fill into the water inlet valve.
If the water can fill into the water inlet valve.
Check if the air dome system is blocked.
Check If the wire connecting the computer
sequencer to the water level sensor is bad.
Select "low" water level and start the machine
to check if the air dome has water.
Switch on the power. Do not push the "start /pause " button.
Replace the water inlet valve.
Replace the computer sequencer.
Clear various factors like the exterior dirty.
Replace the water level sensor.
Replace the wire unit.
It leaks air. Please check and repair the air dome system.
Please smear glue in installation of the connecting pipe.
Please smear glue in installation of the air dome cover.
No
No
No
No
No
At this time please check if the water inlet valve is well.
*Blow from the connecting pipe to the water level sensor
and air doel to see if there is blocking.
CONCERNING KEEP FILLING WATER
Exist
Replace the wire unit
To Next Page
