022-00028AE Operation and Maintenance Manual Operating Controls 2-37
15. EMERGENCY STEERING TEST SWITCH
(OPTION)
This switch is used to test whether the
emergency steering system is properly
functioning.
The system should be tested during the
start-up procedure ensure that the system
is functioning.
Test emergency steering system using the
following procedure;
A. Turn starter switch to "I" (ON)
position.
NOTE:
Do not start engine.
B. Press emergency steering test switch and turn steering wheel at the same time. If system is
functioning properly the unit should steer. The emergency steering indicator light should turn
"ON."
NOTE:
If unit does not steer, do not operate unit until problem is corrected.
C. Release switch. Switch will automatically return to "O" (OFF) position.
WARNING!
Do not press this switch continuously. Continuously pressing switch will cause heavy
battery discharge. The emergency steering DC-motor uses high consumption of
power.
AJO0010L
O
I
Figure 66
To Next Page
Loading...
