Daewoo Mega 200-V - Maintenance Intervals

4-6 Inspection, Maintenance and Adjustment 022-00028AE Operation and Maintenance Manual
MAINTENANCE INTERVALS
10 HOUR / DAILY SERVICE
• Grease Front Attachment Pins (See page
4-8)*
• Inspect All Tires for Correct Tire Pressure
and Signs of Damage or Abnormal Wear
(See page 4-8)
• Check Engine Oil Level (See page 4-8)
• Check Transmission Oil Level (See page
4-9)
• Check Hydraulic System Oil Level (See
page 4-10)
• Check for Leaks in the Hydraulic System
(See page 4-11)
• fill Fuel Tank (See page 4-12)
• Check for Leaks in the Fuel System (See
page 4-12)
• Drain Fuel Condensation (See page 4-13)
• Check Coolant Level (See page 4-13)
• Check Antifreeze Protection Levels (See
page 4-14)
• Check Level of Window Washer Liquid (See
page 4-14)
• Inspect the Bucket Teeth and Side Cutters
for Signs of Wear (See page 4-14)
• Inspect Seat Belt for Proper Operation (See
page 4-15)
• Inspect the Structure for Cracks and Faulty
Welds (See page 4-15)
• Check the Operation of All Switches (See
page 4-15)
• Check the Operation of All Exterior Lights,
Horn and Control Console Indicator and
Monitor Lights (See page 4-15)
• Start Engine, Check Starting Ability, and
Observe Exhaust Color at Start-up and at
Normal Operating Temperature. Listen for
Any Abnormal Sounds (See page 4-15)
• Check Operation of All Controls (See page
4-15)
• Inspect Engine Fan Blade (See page 4-16)
• Check Engine Drive Belt Wear (See page
4-16)
• Check Air Intake System (See page 4-17)
50 HOUR / WEEKLY SERVICE
• Perform All 10 Hour / Daily Service Checks
(See page 4-18)
• Grease Front Attachment Pins (See page
4-18)
• Grease Steering Cylinder Rod and Head
Ends (See page 4-24)
• Grease Upper and Lower Center Pins (See
page 4-25)
• Change Engine Oil and Filter (See page
4-25)*
• Hydraulic Full Flow Filter Replacement
(See page 4-25)*
• Check Water Pump Belt Tension (See page
4-25)*
• Clean Exterior of Radiator, Oil Cooler and
Air conditioner Condenser (See page
4-26)*
250 HOUR / MONTHLY SERVICE
• Perform All 10 Hour / Daily, 50 Hour Service
Checks (See page 4-27)
• Change Engine Oil and Filter (See page
4-25)
• Replace Hydraulic System brake and Pilot
Filter (See page 4-28)
• Check Engine Air Pre-cleaner (See page
4-29)
• Hydraulic Full Flow Filter Replacement
(See page 4-30)
• Clean Air Cleaner (See page 4-31)
• Drain Water From Hydraulic Oil Tank (See
page 4-31)
• Check Water Pump Belt Tension (See page
4-32)
• Grease Drive Shafts (See page 4-33)
• Axle Differential and Planetaries Oil
Replacement (after first 250 hours) (See
page 4-33)*
• Replacement Of Transmission Oil and Filter
(After First 250 Hours) (See page 4-33)*
* Break-In