022-00028AE Operation and Maintenance Manual Operating Controls 2-53
SEAT BELT
SEAT BELT LOCKING AND UNLOCKING
Insert belt end (1, Figure 98) into buckle (2). Pull
belt to check that belt end is locked into buckle.
Adjust belt length so that it comfortably tight
against operator’s pelvic region (hipbone).
Press button (3, Figure 99) in center of buckle
(2) and pull out belt (1) to unlock.
WARNING!
Seat belt is for operator's safety and should be worn at all times. Before driving machine, adjust
seat to desired position for maximum comfort and machine control, then fasten seat belt. Seat
belts must be worn across pelvic region and adjusted snugly to lessen chance and severity of
injury in event of an accident. Never fasten a seat belt across abdomen.
Under no circumstances should operator be standing in cab when operating wheel loader.
Do not adjust seat position while vehicle is moving because a loss of control may result. Stop
machine, apply parking brake, and then adjust seat.
Always, check condition of seat belt and belt bracket before fastening it. Do not use it with twists
in it. Replace belt or bracket if damaged or worn.
HAOB140L
Figure 98
HAOB150L
Figure 99
To Next Page
Loading...
