©
200423 4-17
Removal and installation
EXPLANATORY NOTES ON THE MAINTENANCE ACTIVITIES
ΞΦ95 series
5
Installing the gearbox filter element
1. Check the O-ring of the filter cover (2) for
damage. If necessary, replace the O-ring.
Grease the O-ring.
2. Grease the O-ring of the new filter (3) and
place the filter on the filter cover.
3. Then insert the filter and the filter cover into
the filter housing.
4. Use a plastic mallet to tap the filter cover into
the filter housing.
5. Tighten the attachment bolt (1) to the
specified tightening torque, see main group
"Technical data".
To Next Page
Loading...
