Operation 17
3.7.3 Import/Export Bell Info
Bell information can be imported and exported to/from the terminal. The bell will ring in the
periods you set.
3.7.4 Import/Export Auto Switch Time
Auto switch time can be imported and exported to/from the terminal. Check in, Break out, Break
in, Check out, OT-In, and OT-Out will be displayed on the screen during the period you set.
Feature 3.8
On the main menu, select 5 Feature, and then you can do settings and configurations about
date and time, network communication, features (state switch time, bell time, recheck interval,
verification method, system auto test, attendance event mode, fixed mode setup, and open
door keep time).
3.8.1 Date & Time
On the main menu, select 5 Features > Date & Time, and then you can do settings about date,
time, time zone, DST setting, and network time protocol (NTP).
Date Format
There are three options: YY_MM_DD, DD_MM_YY, and MM_DD_YY.
Y stands for year. M stands for month. D stands for day.
Date Setting
Set a date for the terminal. The date will be displayed on the screen.
Time Setting
Set time for the terminal. The time will be displayed on the screen.
Time Zone
Set time zone for the terminal. The time zone range is GMT–12:00 to GMT+13:00.
DST
You can set daylight saving time.
If you select By Date, you can set start/end date and start/end time of the DST.
If you select By Week, you can set start/end time, month and week of the DST.
To Next Page
Loading...
