Operation 20
3.8.3.6 Att.Event Mode
There are three attendance check mode: Auto/Manual. Fixed, and Forced.
Auto/Manual
In Auto/Manual mode, there are three methods:
You can get your attendance checked directly by pressing your finger at the fingerprint
sensor, by entering your user ID and password, or by swiping your card;
You need to do shift settings in advance in 3 Shift > Shift Setting > Shift. See “3.6.1 Shift
Setting”.
You can select an attendance event by pressing Esc/F1, ∧/F2, ∨/F3, and OK/F4, and
then do fingerprint, password, or card attendance check;
You can get your attendance recorded without doing shift settings and without selecting
attendance events.
Fixed
In the Fixed mode, you can select a fixed attendance event for a terminal, and then users can
sign in at one terminal and sign out at another terminal.
On the standby interface, select 5 Feature > Features > Att. Event Mode.
Step 1
Press OK/F4. Step 2
The white text box appears.
Press ∧/F2 or ∨/F3 to select Fixed. Step 3
Press OK/F4. Step 4
Press ∨/F3. Step 5
Press OK/F4. Step 6
The white text box appears.
Press ∧/F2 or ∨/F3 to select among Check in, Break out, Break in, Check out, OT-In, Step 7
and OT-Out.
Forced
In the Forced mode, you need to select your attendance type (1.Check in; 2.Break out; 3.Break
in; 4.Check out; 5.OT-In; 6.OT-Out) after you press your finger tip at the fingerprint sensor,
enter your user ID and password, or swiping your card.
On the standby interface, select 5 Feature > Features > Att. Event Mode. Step 1
Press OK/F4. Step 2
The white text box appears.
Press ∧/F2 or ∨/F3 to select Forced. Step 3
Press OK/F4. Step 4
To Next Page
Loading...
