Operation 18
NTP Setting
You can set IP, port, and update period (min) for the NTP server.
3.8.2 Communication
On the main menu, select 5 Feature > Communication, and then you can configure IP
address, mask, gateway, MAC, and port. See Figure 3-18.
Communication Figure 3-18
Table 3-2 Parameter description
It is 192.168.1.108 by default.
It is 255.255.255.0 by default.
It is 192.168.1.1 by default.
MAC address of the terminal and it cannot be modified.
Port number, used to login the terminal on the SmartPSS.
3.8.3 Features
Select 5 Feature > Features, and then you can set state switch time, bell time, recheck interval,
verification method, system auto test, attendance event mode, fixed mode setup, and open
door keep time.
3.8.3.1 State Switch Time
You can set state switch time. There are 24 options and six states: Check in, Break out, Break
in, Check out, OT-In, and OT-Out. See Figure 3-19.
To Next Page
Loading...
