Basic Configuration15
Modify IP
Select the mode of setting IP address according to the actual situation.
DHCP (Dynamic Host Configuration Protocol) mode: When there is DHCP server
in the network, set Mode as DHCP, and then the device can automatically acquire
IP address from DHCP server.
Manual mode: Set Mode as Static, and fill in Start IP, Subnet Mask and Gateway,
and then the device IP addresses will be modified successively from start IP.
Select Same IP and the selected device will be set as the same IP address.
Click OK to complete modification.
4.1.3 Device Upgrade
Device upgrade supports single and batch.
Click and the upgrade interface is displayed. See Figure 4-8.
To Next Page
Loading...
Need help?
General
