Basic Configuration17
Batch: Click OK and the system begins to upgrade.
If the device is disconnected during upgrade process, it will continue to upgrade when
the device is connected to network again as long as ConfigTool continues to stay at the
upgrade interface.
Web Login
It supports logging in device WEB interface via browser on PC, and realizes device operation,
configuration and maintenance.
The interface and setting are for reference only. The actual interface shall prevail.
4.2.1 Recommended Config
Please refer to 0 for recommended config of PC which logs in device WEB interface.
PC recommended config
4.2.2 Device Initialization
It needs to implement initialization when it is the first time to log in or it logs in after
restoring factory default setting.
Please confirm that both PC IP and device IP are in the same network segment, otherwise
it fails to enter initialization interface.
Set IP address, subnet mask and gateway of PC and device respectively.
Distribute IP address of the same segment if there is no router in the network.
It needs to set corresponding gateway and subnet mask if there is router in the
network.
The default IP is 192.168.1.108.
Use ping ***.***. ***. *** (device IP address) command and check if network is
connected.
Open browser, input the IP address of the device in the address bar and press Enter.
After it is successfully connected, the Device Initialization interface is displayed. See
Figure 4-10.
To Next Page
Loading...
Need help?
General
